行业新闻

原文
Pulsed solenoid valve installation Precautions: 1, the electromagnetic pulse valve is perpendicular to the best way to install the horizontal pipe, coil up. When the premise is not promised, promised to ± 30 ° tilt. Otherwise, it can not be guaranteed. 2, the solenoid valve on the nameplate parameters should be consistent with the actual requirements. 3, the arrow on the valve body should be consistent with the medium flow. 4, in order to ensure the normal use of solenoid valves, solenoid valve in the oil-water separator before the installation. 5, in a hazardous environment to prevent spark could cause an explosion and other accidents, use explosion-proof solenoid valves. 6, the installation package before and thoroughly purge gas pipeline, foreign body in order to avoid damage caused by the solenoid valve diaphragm failure. 7, when the solenoid valve fails to timely isolation and ease of maintenance, the proposed installation of bypass (bypass) devices. 8, the electromagnetic pulse valve temporarily installed, it can be stored at 0 ~ 40 ℃, relative humidity ≤ 80% or so, but no aggressive gases indoors, try to avoid open storage. 9 out of the box should be checked after a single use of imitation, factory certification, packing list is complete. Then check the list of product names, model are consistent with the control plate is consistent with the order form. If the defect or inconsistent with, the idea should be promptly contact the manufacturer. Valve inlet pump
原文来自：http://www.chinadiancifa.org

是由上海赛泰泵阀有限公司提供的阀门新闻，中文译文仅供参考，以下提供站内导航搜索：

中国电磁阀网电磁阀产品电磁阀知识电磁阀厂商电磁阀博客电磁阀行业新闻

译文：
脉冲电磁阀安装使用时的注意事项：　　1、电磁脉冲阀最佳安装方式是垂直于水平管道，线圈向上。在前提不答应时，答应±30°倾斜。否则，不能保证正常使用。　　2、电磁阀铭牌上的参数应与实际使用要求相符。　　3、电磁阀阀体上的箭头应与介质流向一致。　　4、为保证电磁阀的正常使用，请在电磁阀前加装油水分离器。　　5、在危险环境中为防止电火花可能引发爆炸等事故的发生，应使用防爆型电磁阀。　　6、安装前请彻底吹扫气包及管路，以避免异物损伤膜片造成电磁阀失灵。　　7、当电磁阀发生故障时，为了及时隔离和便于维修，建议安装旁通(旁路)装置。　　8、电磁脉冲阀暂不安装时，可存放在0~40℃，相对湿度≤80%左右，但无侵蚀性气体的室内，尽可能避免露天存放。　　9、开箱后应先检查使用仿单、出厂合格证、装箱清单是否齐全。再按清单核对产品名称、型号是否相符，对照铭牌是否与订货单相符。若缺损或不符，应及时与厂家联系想法。阀门进口泵

更多新闻：